Heating elements

HCPC - Heating / Cooling Perfusion Cube with Peltier element
HPC - Heating Perfusion Cube
HCMIS - Microincubator
H-OBJ - Microscope Objective Heater
HPC-G - Heating perfusion cube for high flow rates
TS-100 - Sensor for npi Temperature Controllers
TS-100S - Sensor only
 
 

For accurate temperature control, sensors near to the solutions to be controlled and effective heating- and/or cooling elements are absolutely necessary. npi offers a variety of these elements, e.g. different sensors, the H-MIC micro incubator (heat only), heating foils and wires.

As distributor for ALA Scientific Instruments in Europe, npi offers also a wide variety of heating/cooling devices.
Please go to ALA product pages for complete information about heating/cooling devices or heating only devices.

Ordering

Part no. Description
TS-100 Temperature sensor for TC/PTC/MTC systems, assembled (2 x 6 mm)
TS-200 Miniature temperature sensor for TC/PTC/MTC systems (assembled, 0.8 x 6 mm)
HCS Microincubator (heat only) for ALA MS-chambers and 35 mm Petri dishes. Fits to EXFO/Lumen Dynamics GIBRALTAR. Easy adaption to any microscope stages.
HCMIS Peltier recording chamber. Temperature Control between 0°C and 45°C possible, ALA MS-chambers and 35 mm Petri dishes supported, easy adaption to any microscope stage
H-OBJ Microscope objective mantle heater. Used to warm up objectives being in contact with the solution (water immersion, upright microscopes) or the coverslip (water/oil immersion, inverted microscopes)
HPC-G Heating perfusion cube, flow rate up to 10 mL/min, low dead volume, built-in thermistor, used to warm up perfusion solutions before they are added to the cell bath. 5 Ohms. Connects thermistor and heater to npi temperature controllers via single ALA DIN cable
HPC-2 Heating perfusion cube, flow rate up to 5 mL/min, low dead volume, built-in thermistor, DIN cable for connection to npi temperature controllers
HCPC Heating/Cooling perfusion cube with peltier elements, flow rate up to 5 mL/min, low dead volume, built-in thermistor, DIN cable for connection to npi temperature controllers
WID02 Heating wire with TEFLON insulation, 12 Ohms, 1 A.
MMT-HPC small magnetic holder for HPC and HPC-G
MMHOLD-HCPC small magnetic holder for HCPC